Omron CS1W-MCH71 Operation Manual page 107

System Parameters
Trace Parameters
(Supported for unit
version 3.0 and later.)
Note
No. Address
M = 1-8 M = 0-7
P05T01 ---
P05T02 ---
P05T03 ---
P05T04 ---
P05T05 ---
P05T06 ---
P05T07 ---
P05T08 ---
P05T09 ---
P05T10 ---
P05T11 ---
P05T12 ---
P05T13 ---
P05T14 ---
P05T15 ---
P05T16 ---
P05T17 ---
P05T18 ---
P05T19 ---
P05T20 ---
P05T21 ---
P05T22 ---
P05T23 ---
P05T24 ---
P05T25 ---
P05T26 ---
P05T27 ---
P05T28 ---
P05T29 ---
P05T30 ---
P05T31 ---
P05T32 ---
P05T33 ---
P05T34 ---
62
Abbreviation in the No. column: T = 1 or 2 (trace group number)
Name
Number of trace points and trace data
Trace start at power ON
Delay
Trace start trigger 1: Left-side variable
type/form
Trace start trigger 1: Left-side address
Trace start trigger 1: Criteria
Trace start trigger 1: Right-side vari-
able type
Trace start trigger 1: Right-side
address or immediate value
Trace start trigger 2: Left-side variable
type/form
Trace start trigger 2: Left-side address
Trace start trigger 2: Criteria
Trace start trigger 2: Right-side vari-
able type
Trace start trigger 2: Right-side
address or immediate value
Trace item 1: Form/type
Trace item 1: Address
Trace item 2: Form/type
Trace item 2: Address
Trace item 3: Form/type
Trace item 3 Address
Trace item 4: Form/type
Trace item 4: Address
Trace item 5: Form/type
Trace item 5: Address
Trace item 6: Form/type
Trace item 6: Address
Trace item 7: Form/type
Trace item 7: Address
Trace item 8: Form/type
Trace item 8: Address
Trace item 9: Form/type
Trace item 9: Address
Trace item 10: Form/type
Trace item 10: Address
Trace item 11: Form/type
Function
These parameters are used to set trig-
ger conditions, numbers of data items to
be traced, addresses of variables to be
traced, and trace timing. These parame-
ters can be set only by using the Sup-
port Tool. They cannot be set by IOWR
instructions in ladder programs or by
PARAM commands in motion programs.
When these parameters are saved from
the ladder program, they are saved in
the MC Unit's FROM just as with other
parameters.
The CPU easy backup operation can
also be used to save these parameters
to CF (Compact Flash), and to the MC
Unit's F-ROM from the CF.
For details on these parameters, refer to
the CX-Motion-MCH Operation Manual
(supported by version 2.0 or later).
Section 4-2
Page
---