Position Data Address; Position Data Configuration; Indirect Specification - Omron CS1W-MCH71 Operation Manual

Position Data
4-4-1

Position Data Address

4-4-2

Position Data Configuration

4-4-3

Indirect Specification

1,2,3...
108
Specify position data at the following addresses in MC Unit memory. Specify
the addresses in hexadecimal when using IOWR/IORD instructions.
Data IORD/IOWR control Address
Position Data 0000 to 27FF Hex (deci-
mal:0000 to10239)
In MC Unit programming, the position data address is specified as a type of
variable as shown below:
PL<Address No.>: Specify 0000 to 27FF as the address No.
(Example)
MOVE_[J1]#PL01FF
Each position data is comprised of two words (4 bytes). Though the position
data of the MC Unit does not have a decimal point decimal, however, a deci-
mal point is added to the data based on the setting of Position command dec-
imal point position (P5AA02) in Axis-machine parameters.
Data Range
− 2147483648 to +2147483647 (80000000 Hex to 7FFFFFFF Hex)
15
j+0 Position Data (Signed 32-bit, lower 16 bits)
j+1 Position Data (Signed 32-bit, upper 16 bits)
Example 1: Position data 12345 (00003039 Hex)
15 12 11
j+0 3
j+1 0
When Units (P5AA01) of Axis-machine parameters is 0: mm and Position
command decimal point position (P5AA02) is 3: 0.001, the position data
12345 is handled as 12.345 mm.
Example 2: Position data − 12345 (FFFFCFC7 Hex)
15 12 11
j+0 C
j+1 F
When Units (P5AA01) of Axis-machine parameters is 1: inch and Position
command decimal point position (P5AA02) is 2: 0.01, the position data -12345
is handled as − 123.45 inch.
Indirect specification can be used only for position data.
1. Add the symbol @ in front of position data, indicating to use the position
data specified by the stored data (address).
• As shown below, @PL0001 specifies the stored data 0012 of the position
data PL0100.
range
1 word: 0002 Hex, 2 words:
0004 Hex, 3 words: 0006 Hex, 4
words: 0008 Hex
08 07 04 03
0
3
0 0
08 07 04 03
F C
F F
Section 4-4
No. of transferred words
00
00
9
0
00
7
F