Setting And Reading A Program Memory Address; Instruction Search - Omron SYSMAC CPM1 Operation Manual

Programming Console Operations
Key Sequence
1, 2, 3...

4-3-5 Setting and Reading a Program Memory Address

1, 2, 3...

4-3-6 Instruction Search

1, 2, 3...
62
Follow the procedure below to turn the key-input buzzer on and off.
1. Press the CLR, SHIFT, and then the CLR Key to bring up the mode display.
In this case the PC is in PROGRAM mode and the buzzer is on.
2. Press the SHIFT and then the 1 Key to turn off the buzzer.
SHIFT
3. Press the SHIFT and then the 1 Key again to turn the buzzer back on.
SHIFT
This operation is used to display the specified program memory address and is
possible in any mode.
RUN
OK OK
When inputting a program for the first time, it is generally written to Program
Memory starting from address 000. Because this address appears when the
display is cleared, it is not necessary to specify it.
When inputting a program starting from other than 000 or to read or modify a
program that already exists in memory, the desired address must be desig-
nated.
1. Press the CLR Key to bring up the initial display.
2. Input the desired address. It is not necessary to input leading zeroes.
C A
2 0
3. Press the Down Arrow Key.
Note The ON/OFF status of any displayed bit will be shown if the PC is in
RUN or MONITOR mode.
4. Press the Up and Down Arrow Keys to scroll through the program.
This operation is used to find occurrences of the specified instruction in the pro-
gram and is possible in any mode.
RUN
OK OK
The ON/OFF status of any displayed bit will be shown if the PC is in RUN or
MONITOR mode.
1. Press the CLR Key to bring up the initial display.
<MONITOR>
<MONITOR>
B
1
<MONITOR>
B
1
MONITOR PROGRAM
OK
00200
A
0
00200READ
↓
LD
00201READ
↓
AND
00200READ
↑
LD
MONITOR PROGRAM
OK
Section 4-3
BZ
BZ
OFF
00000
ON
00001
OFF
00000