Park Pin Switch Test
SRS components are located in this area. Review the
SRS component locations (see page 23-18), and the
precautions and procedures (see page 23-21) in the SRS
before performing repairs or service.
1. Remove the steering column covers (see page 17-
25).
2. Disconnect the park pin switch connector.
3. Shift the shift lever into the P position, then check
for continuity between the No. 1 and No. 3
terminals. There should be no continuity.
4. Shift the shift lever out of the P position, and check
for continuity between the terminals in step 3.
There should be continuity.
5. If the park pin switch is faulty, replace the control
bracket assembly. (The park pin switch is not
available separately.)
14-187