Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
permit ( IP )
Use the permit IP Access-list Configuration mode command to set permit
conditions for IPv4 access list.
Syntax
protocol {any | source source-wildcard} {any | destination
permit
destination-wildcard} [dscp number | precedence number] [time-range
time-range-name]
icmp {any | source source-wildcard} {any | destination destination-
permit
wildcard} [any | icmp-type] [any | icmp-code]] [dscp number | precedence
number] [time-range time-range-name]
igmp {any | source source-wildcard} {any | destination destination-
permit
wildcard}[igmp-type] [dscp number | precedence number] [time-range
time-range-name]
{any | source source-wildcard} {any|source-port/port-range}{any
permit tcp
| destination destination-wildcard} {any|destination-port/port-range } [dscp
number | precedence number] [match-all list-of-flags] [time-range time-
range-name]
{any | source source-wildcard} {any|source-port/port-range}
permit udp
{any | destination destination-wildcard} {any|destination-port/port-range }
[dscp number | precedence number] [match-all time-range-name] [time-
range time-range-name]
Parameters
protocol—The name or the number of an IP protocol. Available protocol
•
names icmp, igmp, ip, tcp, egp, igp, udp, hmp, rdp, idpr, ipv6, ipv6:rout,
ipv6:frag, idrp, rsvp, gre, esp, ah, ipv6:icmp, eigrp, ospf, ipinip, pim, l2tp,
isis. To match any protocol use the ip keyword.(Range: 0–255)
source—Source IP address of the packet.
•
source-wildcard—Wildcard bits to be applied to the source IP address.
•
Use ones in the bit position that you want to be ignored.
destination—Destination IP address of the packet.
•
destination-wildcard—Wildcard bits to be applied to the destination IP
•
address. Use ones in the bit position that you want to be ignored.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 2 0 1 2 - F O R P R O O F O N LY
696
CLI\files\ACL.fm
Advertisement
Table of Contents
