Honda 2004 Odyssey Service Manual page 1802

Combination Light Switch Test/Replacement
1. Remove the driver's dashboard lower cover (see page 20-69).
2. Remove the steering column covers (see page 17-25).
3. Disconnect the 14P connector (A) from the combination light switch (B).
4. Remove the two screws, then pull out the combination light switch.
5. Inspect the connector terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, check for continuity between the terminals in each switch position according to the
tables.
Light switch:
Position
Headlight switch
Passing switch
*1: With auto-off headlight function
*2: Canada
Turn signal switch:
Terminal
Position
LEFT
NEUTRAL
RIGHT
6. If the continuity check is not as specified in the table, replace the switch.
A
B
Terminal
3
(*1)
OFF
LOW
HIGH
OFF
ON
12 13 14
4 8 9 10
(*2)
11 6 7
22-123