Setting To Output System Information To The Snmp Nms - H3C S5500-EI series Operation Manual

Operation Manual – Information Center
H3C S5500-EI Series Ethernet Switches
Configure the format of
the timestamp

1.2.7 Setting to Output System Information to the SNMP NMS

Enter system view
Enable information
center
Name the channel with
a specified channel
number
Configure the channel
through which system
information can be
output to the SNMP
NMS
Configure the output
rules of the system
information
Configure the format of
the timestamp
Note:
To ensure that system information can be output to the SNMP NMS, you need to make
the necessary configurations on the SNMP agent and the NMS. For detailed
information on SNMP, refer to the SNMP-RMON Configuration part of the manual.
To do...
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
To do...
system-view
info-center enable
info-center channel
channel-number name
channel-name
info-center snmp channel
{ channel-number |
channel-name }
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug
{ level severity | state state }
* | log { level severity | state
state } * | trap { level severity
| state state } * ] *
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Chapter 1 Information Center Configuration
Use the command...
Use the command...
1-13
Remarks
Optional
The time stamp format for
log, trap and debugging
information is date by
default.
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 1-2 for
default channel names.
Optional
System information is
output to the SNMP NMS
by default with channel 5
(known as snmpagent) as
the default channel.
Optional
Refer to Table 1-4 for the
output rules of the system
information.
Optional
The time stamp format for
log, trap and debugging
information is date by
default.