Configuring Synchronous Information Output; Configuring To Display The Time Stamp With The Utc Time Zone - H3C S3100 Series Operation Manual

H3c s3100 series ethernet switches operation manual

Hide thumbs Also See for S3100 Series:

Table of Contents

Setting to Output System Information to the SNMP NMS

Configuring Synchronous Information Output

Synchronous information output refers to the feature that if the system information such as log, trap, or

debugging information is output when the user is inputting commands, the command line prompt (in

command editing mode a prompt, or a [Y/N] string in interaction mode) and the input information are

echoed after the output.

This feature is used in the case that your input is interrupted by a large amount of system output. With

this feature enabled, the system echoes your previous input and you can continue your operations from

where you were stopped.

Table 1-5 Configure synchronous information output

Enter system view

Enable synchronous information

If the system information is output before you input any information following the current command

line prompt, the system does not echo any command line prompt after the system information

In the interaction mode, you are prompted for some information input. If the input is interrupted by

system output, no system prompt (except the Y/N string) will be echoed after the output, but your

input will be displayed in a new line.

To add UTC time zone to the time stamp in the information center output information, you must:

Set the local time zone

Set the time stamp format in the output direction of the information center to date

Configure to add the UTC time zone to the output information

Table 1-6 Configure to display time stamp with the UTC time zone

Set the time zone for the system

Enter system view

info-center synchronous

clock timezone zone-name { add |

minus } time

Disabled by default

By default, UTC time zone is

set for the system.

Table of Contents