Debug Commands - D-Link xStack DGS-3400 Series Cli Reference Manual

xStack
Software Debug is used to define the common behavior of each module's debug function and collect and save basic OS
information when exceptions happen.
The Debug commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
debug error_log
debug buffer
debug output
debug config error_reboot
debug show status
debug config state
debug show error_reboot state
Each command is listed, in detail, in the following sections.
debug error_log
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
[utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
[module <module_list> | all] [buffer | console]
[enable | disable]
{ module <module_list> }
[enable | disable]
Use this command to dump, clear or upload the software error log to a TFTP server.
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Dump, clear or upload the debug log to a TFTP server. The "error log" here refers to the
software error log stored in NVRAM.
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specifies the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname.
Only Administrator and Operator-level users can issue this command.
112
16
D C
EBUG OMMANDS