Debug Software Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

Debug Software Commands

The Debug Software commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
debug error_log
debug buffer
debug output
debug config
debug config error_reboot
debug status show
debug config state
debug error_reboot show state
Each command is listed, in detail, in the following sections.
debug error_log
Purpose Use this command to dump, clear or upload the software error log to a TFTP server.
Syntax debug error_log [dump | clear | upload_toTFTP [<ipaddr> | <ipv6addr> |
<domain_name 255>] <path_filename 64>]
Description Use this command to dump, clear or upload the software error log to a TFTP server.
Parameters dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specifies the IPv4 address of the TFTP server.
<ipv6addr> - Specifies the IPv6 address of the TFTP server.
<domain_name 255> - The domain name of the TFTP server. The max length of domain
name is 255.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To dump the error log:
DES-3528:admin#
Command: debug error_log dump
**************************************************************************
# debug log: 1
# level: fatal
# clock: 10000ms
# time : 2013/03/11 13:00:00
====================== SOFTWARE FATAL ERROR =======================
Invalid mutex handle : 806D6480
Current TASK : bcmARL.0
------------------------- TASK STACKTRACE ------------------------
->802ACE98
Parameters
[dump | clear | upload_toTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>]
<path_filename 64>]
[utilization | dump | clear | upload_toTFTP [<ipaddr> | <ipv6addr> |
<domain_name 255>] <path_filename 64>]
[module <module_list> | all] [buffer | console]
[module <module_list> | all] [enable | disable]
[enable | disable]
{module <module_list>}
[enable | disable]
debug error_log dump
520