Backup Programming-Manual (#124) - Avaya PARTNER ACS Installation And Use Manual

Programming
To change the setting for Backup Programming–Automatic:
1. Check that only one Backup/Restore PC Card is in the processor module.
2. Press f00ss#123
The current setting appears.
3. To change the setting, press
r
to return the setting to the factory setting. The possible settings are:
1 = Active
I
2 = Not Active (the factory setting) ✔
I
3 = Backup Alarm Cleared
I
4. Exit programming mode.
For information about using Option 3, Backup Alarm Cleared, see
Alarm" on page 11-4.
Backup Programming–Manual (#124)
Use this feature to manually back up all the programming (except the system date, day, and time)
to a Backup/Restore PC Card.
Programming
To begin a manual backup of system settings:
1. Verify that only one Backup/Restore Card is in the processor module.
2. Press f00ss#124
If there is a problem, one of the following messages appears (see
"Troubleshooting"
I
Card is Write Protected
I Insert Valid Card
I
SystemBusy
If there is no problem, the display instructs you to press Enter to begin the backup.
e
3. Press .
A status message is displayed indicating that a backup is in progress, and within 30 seconds,
a message appears indicating the result.
If the backup was successful, the new backup information replaces the information in the old
MAN.mmddyy file on the Backup/Restore PC Card, and the mmddyy extension now reflects
the current date. Backup information created during a manual backup does not overwrite any
AUTO.mmddyy file.
D
or
for explanations and corrective actions):
at extension 10 or 11.
d
until the setting you want appears, or press
"Clearing a Backup-Failure
at extension 10 or 11.
Programming System Options
Chapter 11,
Backup and Restore
4-5