Configure Debug-Trace Iparp - Extreme Networks ExtremeWare Command Reference Manual

configure debug-trace iparp

configure debug-trace iparp <debug level> vlan <vlan name>
Description
This command records debug information to the syslog.
Syntax Description
debug Specifies a debug level:
0 — Records IP and ARP conflicts, and duplicate IP addresses.
1 — Records the following errors:
2 — Records the following errors:
3 — No additional information recorded.
4 — No additional information recorded.
5 — No additional information recorded.
vlan name Specifies a VLAN name.
Default
The default level is 0.
ExtremeWare 7.7 Command Reference Guide
• ARP interface down
• No bridge for router interface
• No free new entry
• Filter out multicast and broadcast source address
• Header too short
• ARP Ethernet/IP
• Invalid hw/prot length
• Wrong length
• Router interface down
• Bad IP destination
• No mbuf available
• Failed to ARP
• SubVLAN proxy ARP disabled, replied, or ARPing
NOTE: This error is supported only on the "i" series switches.)
• No bridge available
• No ARP available
• No router interface in ARPT
• Loopback entry created
• Suppressed re-ARP
• New ARP entry for IP/MAC address
• Filtering own ARP
• Target matched primary, secondary, or backup
configure debug-trace iparp
1191