Extreme Networks ExtremeWare Command Reference Manual page 725

For ExtremeWare 6.1, the system always reboots after a task exception when the system recovery level
is specified as
For ExtremeWare 6.2 or later, you must specify whether the system should shut down or reboot upon a
task exception if the recovery level is
For BlackDiamond Switches. For ExtremeWare 6.2.2 or later, if
BlackDiamond switch and there is a software exception on the master MSM, the interrupt handler
triggers the slave MSM to take over control of the switch.
Examples
The following command configures a switch to reboot after a critical task exception occurs:
configure sys-recovery-level critical reboot
The following command configures the Master MSM to failover to the Slave MSM if a software
exception occurs:
configure sys-recovery-level critical msm-failover
History
This command was first available in ExtremeWare 6.1.
Modified in ExtremeWare 6.2 to support the
Modified in ExtremeWare 6.2.2 to support the
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Modified in ExtremeWare 7.2e to support the
Platform Availability
This command is available on all i-series switches. The
BlackDiamond switch only.
ExtremeWare 7.7 Command Reference Guide
or .
all critical
all
or .
critical
msm-failover
and
shutdown reboot
option.
msm-failover
and
shutdown reboot
msm-failover
configure sys-recovery-level
is specified on a
options.
options.
option is available on the
725