Extreme Networks ExtremeWare Command Reference Manual page 697

• severity—on
• event-name—condition
• host-name—off
• priority—off
• tag-id—off
• tag-name—off
• sequence-number—off
• process-name—off
• process-id—off
• source-function—off
• source-line—off
The following defaults apply to syslog targets (per RFC 3164):
• timestamp—seconds
• date—mmm-dd
• severity—on
• event-name—none
• host-name—off
• priority—on
• tag-id—off
• tag-name—on
• sequence-number—off
• process-name—off
• process-id—off
• source-function—off
• source-line—off
Usage Guidelines
This command configures the format of the items that make up log messages. You can choose to
include or exclude items and set the format for those items, but you cannot vary the order in which the
items are assembled.
When applied to the targets
messages sent to the console display or telnet session. Configuration changes to the
either a telnet or console display target session, are in effect only for the duration of the session, and are
not saved in FLASH.
When this command is applied to the target
and
show log
overridden by specifying a format on the
When this command is applied to the target
to the specified syslog host.
ExtremeWare 7.7 Command Reference Guide
console-display
commands. The format configured for the internal memory buffer can be
upload log
or , the format specified is used for the
session
, the format specified is used in subsequent
memory-buffer
and
show log upload log
, the format specified is used for the messages sent
syslog
configure log target format
target, be it
session
commands.
697