Create Rate-Limit - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

create rate-limit

create rate-limit <rule_name> access-mask <access-mask name> {dest-mac
<dest_mac>} {source-mac <scr_mac>} {vlan <name>} {ethertype [IP | ARP |
<hex_value>]} {tos <ip_precedence> | code-point <code_point>} {ipprotocol
[tcp | udp | icmp | igmp | <prococol_num>]} {dest-ip <dest_IP>/<mask
length>} {dest-L4port <dest_port>} {source-ip <src_IP>/<mask length>}
{source-L4port <src_port> [permit {qosprofile <qosprofile>} {set code-point
<code_point>} {set dot1p <dot1p_value} limit <rate_in_Mbps> {exceed-action
[drop | set code-point <code_point>]} {vlan-pri}{vlan-pri-2bits}
Description
Creates a rate limit rule.
NOTE
This command is available only on the "e" series switches.
Syntax Description
rule_name Specifies the name of the rate limit rule.
access-mask Specifies the name of the associated access mask.
dest-mac Specifies the destination MAC address.
source-mac Specifies the source MAC address.
vlan Specifies the VLANid.
ethertype Specifies the Ethernet type field.
tos Specifies a 3-bit precedence field within the IP ToS field. Valid entries are from 0 to 7.
code-point Specifies a 6-bit DiffServ code point. Valid entries are from 0 to 63.
iprotocol Specifies the IP protocol.
dest-ip Specifies the destination IP address.
source-ip Specifies the source IP address.
dest-L4port Specifies the destination TCP/UDP port.
source-L4port Specifies the source TCP/UDP port.
icmp-type Specifies the ICMP type.
icmp-code Specifies the ICMP code.
egressport Specifies the egress port.
ports Specifies one or more ingress ports.
permit Specifies to forward the packet.
qosprofile Specifies the priorities for using QoS profiles.
code-point Specifies a 6-bit DiffServ code point. Valid entries are from 0 to 63.
dot1p Specifies the priorities for 802.1p.
limit Specifies to limit the data rate to the specified amount in Mbps.
exceed-action Specifies the action to be taken on the data traffic when it exceeds the specified amount.
vlan-pri Specifies the 802.1p priority of the VLAN tag, which is a three-bit field. Valid values are
0 to 7.
974 ExtremeWare 7.7 Command Reference Guide