Show Wireless Ports Interface Rf-Status - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

show wireless ports interface rf-status

show wireless ports [<portlist> | all] interface [1 | 2] rf-status {detail}
Description
Displays data rates for the selected port and interface. If Dynamic Frequency Selection (DFS) is used,
the detail command output includes a list of channels on which interference is detected.
Syntax Description
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form
1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
detail Specifies to display the information in detailed format.
Default
N/A
Usage Guidelines
Each wireless port on the Summit 300 contains two interfaces. Interface 1 supports 802.11a, and
interface 2 supports 802.11b/g radio signals. The
command allows you to display information about one of the two individual interfaces (1|2) on a port
or ports.
Examples
The following example displays RF status of all active ports of the switch:
show wireless ports all interface 1 rf-status
Port Intf Tx Rate
--------------------------------------------------------------
1:37 1 54
1:38 1 54
The following command shows detailed RF status. The output includes a list of channels recorded in
the no-occupancy list (NOL) due to RADAR interference for the DFS feature.
show wireless ports all interface 1 rf-status detail
Wireless Interface:
Transmit Rate:
Beacon Interval:
DTIM:
Preamble:
Long Retry:
Short Retry:
Fragmentation Length:
RTS Threshold:
1426
show wireless port interface rf-status
Channel Noise Floor
64 85
64 84
15:1
54
40
2
Short
7
4
2345
2330
ExtremeWare 7.7 Command Reference Guide