Configure Rf-Profile Frag-Length - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

Wireless Commands

configure rf-profile frag-length

configure rf-profile <name> frag-length <value>

Specifies the fragment size in bytes.

Syntax Description

Specifies the names of the RF profile.

Specifies the fragment size in bytes. Valid values are from 256 to 2345.

Usage Guidelines

This value should remain at its default setting of 2345. It specifies the maximum size for a packet before

data is fragmented into multiple packets. If you experience a high packet error rate, you may slightly

increase the fragmentation threshold. Setting the fragmentation threshold too low may result in poor

network performance. Only minor modifications of this value are recommended.

The following command sets the fragment size to the default setting:

configure rf-profile rfprof1 frag-length 2345

This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.

Platform Availability

This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine

ExtremeWare 7.7 Command Reference Guide

Extremeware 7.7