Configure Sys-Hardware-Recovery Poll-Interval - Extreme Networks ExtremeWare Command Reference Manual

configure sys-hardware-recovery poll-interval

configure sys-hardware-recovery poll-interval
configure sys-hardware-recovery poll-interval <seconds>
Description
Configures the polling interval for the hardware recovery mechanism for a switch or module with a
processor in a hang state.
NOTE
This command is available only on the "i" series switches.
Syntax Description
seconds The polling interval in seconds for the system hardware recovery mechanism.
Default
The default value is 30 seconds.
Usage Guidelines
The value set by this command is valid only when the hardware recovery mechanism is enabled in
active polling mode.
Example
The following command sets the polling interval to 160 seconds:
configure sys-hardware-recovery poll-interval 160
History
This command was first available in ExtremeWare 7.6.
Platform Availability
This command is available only on the "i" series platforms.
ExtremeWare 7.7 Command Reference Guide 775