Configure Wireless Ports Interface Ap-Scan Send-Probe - Extreme Networks ExtremeWare Command Reference Manual

configure wireless ports interface ap-scan send-probe

configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
send-probe <on |
Description
Use this command to enable the sending of probes for active scanning.
Syntax Description
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form
1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
on Specifies to send probes (active scanning).
off Specifies not to send probes (passive scanning).
Default
Off
Usage Guidelines
Use this command to enable the sending of probes. Setting
Setting
send-probe
Example
The following example enables the port range 1:15-1:24 using interface 1 to enable probes.
configure wireless ports 1:15-1:24 interface 1 ap-scan send-probe on
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine
switches.
ExtremeWare 7.7 Command Reference Guide
off>
to specifies passive scanning.
off
configure wireless ports interface ap-scan send-probe
to specifies active scanning.
send-probe on
1325