Show Wireless Ports Interface Ap-Scan Status - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

show wireless ports interface ap-scan status

show wireless ports [<portlist> | all] interface [1|2] ap-scan status
Description
Displays the status of the AP scan for the port and interface.
Syntax Description
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form
1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
Default
N/A
Usage Guidelines
Use this command to check the AP scan status on a particular port and interface.
Examples
The following command shows the status of the AP scan for the port and interface:
show wireless port 1:5 interface 1 ap-scan status
The output of the command is similar to the following:
Intf Enabled Num-Probes Num-APs WaterMark TimeOuts Overflows OCS
-------------------------------------------------------------------------------
1:1 N 0
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine
switches.
1402
0 0 0 0 N
ExtremeWare 7.7 Command Reference Guide