Configure Wireless Country-Code - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

configure wireless country-code

configure wireless country-code <code>

Configures the country identifier for the switch.

Syntax Description

Sets the country identifier for the switch.

Extreme_default

Usage Guidelines

When the Summit 300 is set to factory defaults, you must configure the correct country code using the

country code properties listed in the following table. The country code feature allows you to configure

the approved 802.11a or 802.11b/g "channels" applicable to each of the supported countries.

extreme_default

Extreme Networks ships the Summit 300 to be programmed with Extreme Network's special

extreme_default

radio. When an Altitude 300 wireless port is connected and the Summit 300 is unable to determine the

country for which the Altitude is programmed, then the

must program the country code on the Summit 300 to enable the remaining channels for the desired

The Altitude 300 wireless port is shipped with a pre-programmed code for the following countries:

• North America (United States, Canada, Hong Kong)

• European Union and the Rest of the World.

If you do not program the country code in the Summit 300, then the switch inherits the country code of

the first Altitude 300 wireless port that connects to it, if the Altitude is not programmed for the

'European Union and the Rest of World.

If there is a mismatch between the country codes between the Altitude 300 wireless port and the code

programmed on the Summit 300, the Altitude 300 wireless port is not allowed to come up.

ExtremeWare 7.7 Command Reference Guide

country code, which brings up only the B/G radio in channel 6, and turns off the A

Korea_Republic

country code is used. You

extreme_default

configure wireless country-code

Liechtenstein

Extremeware 7.7