Configure Transceiver-Test Failure-Action - Extreme Networks ExtremeWare Command Reference Manual

configure transceiver-test failure-action

configure transceiver-test failure-action [log | sys-health-check]
Description
Configures the action the switch takes if too many failures are detected within the specified window.
NOTE
This command is available only on modular switches.
Syntax Description
log
sys-health-check
Default
Log
Usage Guidelines
If you select
If you select
configured system health check action. To configure the system health checker, use the
sys-health-check alarm-level
The alarm-level and auto-recovery options are mutually exclusive; configuring an alarm level disables
auto-recovery, and configuring auto-recovery overrides the alarm-level setting.
By default, the switch checks for errors within the last eight 20-second windows. Use the
transceiver-test window
To determine if you have the transceiver test enabled and the failure action the switch takes, use the
show switch
Transceiver Diag: Enabled.
For ExtremeWare 6.2.2b108:
The default is
Example
The following command configures the switch to perform the configured system health check action if
too many failures are detected:
configure transceiver-test failure-action sys-health-check
History
This command was first available in ExtremeWare 6.2.2b108.
ExtremeWare 7.7 Command Reference Guide
Specifies that messages are sent to the syslog.
Specifies that the configured system health check action is taken.
, only one instance of an error message is logged at this level.
log
and the switch detects too many failures, the switch takes the
sys-health-check
or the
command to modify the number of windows.
command. The following is sample transceiver test output:
Failure action:
, and the switch takes the configured system health check action.
sys-health-check
configure sys-health-check auto-recovery
log only
configure transceiver-test failure-action
configure
command.
configure
729