Extreme Networks ExtremeWare Command Reference Manual page 1478

EAPS Commands
State:
[Running: ...]
Enabled:
Mode:
Primary/Secondary port:
Port status:
Tag status:
Hello Timer interval:
Fail Timer interval:
1478
On a transit node, the command displays one of the following states:
• Idle—The EAPS domain has been enabled, but the configuration is not
complete.
• Links-Up—This EAPS domain is running, and both its ports are up and in
the FORWARDING state.
• Links-Down—This EAPS domain is running, but one or both of its ports are
down.
• Preforwarding—This EAPS domain is running, and both of its ports are up,
but one of them is in a temporary BLOCKED state.
On a master node, the command displays one of the following states:
• Idle—The EAPS domain has been enabled, but the configuration is not
complete.
• Init—The EAPS domain has started but has not yet determined the status of
the ring. The secondary port is in a BLOCKED state.
• Complete—The ring is in the COMPLETE state for this EAPS domain.
• Failed—There is a break in the ring for this EAPS domain.
• [Failtimer Expired]—When the failtimer expires and it's action is set to
send-alert, this flag is set. This flag indicates there is a misconfiguration or
hardware problem in the EAPS ring. The EAPS master node will continue to
remain in COMPLETE or INIT state with it's secondary port blocking.
• Yes—This EAPS domain is running.
• No—This EAPS domain is not running.
Indicates whether EAPS is enabled on this domain.
• Y—EAPS is enabled on this domain.
• N—EAPS is not enabled.
The configured EAPS mode for this switch: transit (T) or master (M).
The port numbers assigned as the EAPS primary and secondary ports. On the
master node, the port distinction indicates which port is blocked to avoid a
loop.
• Unknown—This EAPS domain is not running, so the port status has not yet
been determined.
• Up—The port is up and is forwarding data.
• Down—The port is down.
• Blocked—The port is up, but data is blocked from being forwarded.
Tagged status of the control VLAN:
• Tagged—The control VLAN has this port assigned to it, and the port is
tagged in the VLAN.
• Untagged—The control VLAN has this port assigned to it, but the port is
untagged in the control VLAN.
• Undetermined—Either a VLAN has not been added as the control VLAN to
this EAPS domain or this port has not been added to the control VLAN.
The configured value of the timer in seconds, specifying the time that the
master node waits between transmissions of health check packets.
The configured value of the timer in seconds, specifying the time that the
master node waits before the failtimer expires.
ExtremeWare 7.7 Command Reference Guide