Show Wireless Ports Interface Security-Status - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

show wireless ports interface security-status

show wireless ports [<portlist> | all ] interface [1 |2] security-status
{detail}
Description
Displays Wired Equivalent Privacy
for the selected port and interface.
Syntax Description
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form
1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all active ports.
interface Specifies an interface: 1 or 2.
detail Specifies to display the information in detailed format.
Default
N/A
Usage Guidelines
Each wireless port on the switch contains two interfaces. Interface 1 supports 802.11a, and interface 2
supports 802.11b/g radio signals. The
allows you to display security status information about one of the two individual interfaces (1|2) on
one or more ports.
Examples
The following example displays the security setting of all active wireless ports of the switch:
show wireless ports all interface 2 security-status
The output of the command is similar to:
Port Intf Dot11 Auth
-------------------------------------------------------------------------------
1:37 2 shared
1:38 2 open
The following example shows the detailed security setting of all active wireless ports of the switch:
show wireless ports all interface 2 security-status detail
The output of the command is similar to:
Wireless Interface:
Dot11 Authentication:
Network Authentication:
ESS Name:
Encryption:
1428
(
WEP) protocol, authentication, dot1x, and ESS name information
show wireless port interface security-status
Network Auth ESS
none TFZ
none fz-open-wep-64
1:37:2
shared
none
TFZ
wep128
command
ExtremeWare 7.7 Command Reference Guide