Extreme Networks ExtremeWare Command Reference Manual page 716

Commands for Status Monitoring and Statistics
In ExtremeWare versions prior to 6.2, you cannot use both mirroring and the system health checker at
the same time. If you configure mirroring with the system health checker enabled, the health checker
will indicate that it has been disabled by sending a message to the syslog. In ExtremeWare 6.2 or later,
this restriction does not apply.
To view the status of the system health checker, use the
To enable the health checker, use the
To disable the health checker, use the
The alarm-level
system-down
system is backed by an identical system. By powering down the faulty system, you ensure that erratic
ESRP behavior in the faulty system does not affect ESRP performance and ensures full system failover
to the redundant system.
If you are using ESRP with ESRP diagnostic tracking enabled in your configuration, a system health
check failure automatically reduces the ESRP priority of the system to the configured failover priority.
This allows the healthy standby system to take over ESRP and become responsible for handling traffic.
I/O module faults are permanently recorded on the module's EEPROM. A module that has failed a
system health check cannot be brought back online.
To view the failure messages, use the
Example
The following command configures the system health checker to post a CRIT message to the log and
send a trap:
configure sys-health-check alarm-level traps
History
This command was first available in ExtremeWare 6.1.9.
The system health check functionality was modified in ExtremeWare 6.2.1 to support packet memory
defect detection and mapping on selected I/O modules.
This command was modified in ExtremeWare 6.2.2 to support system health check and checksum error
checking and to add the
Platform Availability
This command is available only on the Alpine, BlackDiamond, and Summit "i" series switches.
716
enable sys-health-check
disable sys-health-check
option is especially useful in an ESRP configuration where the entire
show diagnostics
and parameters.
online offline
command.
show diagnostics
command.
command.
command.
ExtremeWare 7.7 Command Reference Guide