Configure Wireless Ports Interface Ap-Scan Removed-Trap - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

configure wireless ports interface ap-scan removed-trap

configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
removed-trap [on | off]
Description
Use this command to have the access point (AP) scan to send an SNMP trap when new stations are
removed from the results table.
Syntax Description
portlist Specifies one or more ports or slots and ports. Can be one or more port numbers. May be in the form
1, 2, 1:2, 3-5, 2:*, 2:5, 2:6-2:8.
all Specifies all ports.
interface Specifies an interface: 1 or 2.
on Specifies that the AP scan should send an SNMP trap when new stations are removed from the
results table.
off Specifies that the AP scan should not send an SNMP trap when new stations are removed from the
results table.
Default
Off
Usage Guidelines
Use this command to see a trap when stations are removed from the results table.
Example
The following command configures port 18 on the Summit 300-24 to have the AP scan to send an
SNMP trap when new stations are removed from the results table:
configure wireless ports 18 interface 2 ap-scan removed-trap on
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine
switches.
1322 ExtremeWare 7.7 Command Reference Guide