Configure Auth Mgmt-Access Radius - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

configure auth mgmt-access radius

configure auth mgmt-access radius primary [<ipaddress> | <hostname>]
{secondary [<ipaddress> | hostname]}
Description
Configures authentication of management sessions for RADIUS servers.
Syntax Description
primary Configures the primary RADIUS authentication server that is used for management sessions.
secondary Configures the secondary RADIUS authentication server that is used for management sessions.
ipaddress The IP address of the authentication server.
hostname The host name of the authentication server.
Default
Uses RADIUS for authentication for management sessions. If RADIUS is not enabled, TACACS+ servers
are used. If neither RADIUS nor TACACS+ servers are configured, local authentication is used.
Usage Guidelines
Use this command to authenticate all the management sessions through RADIUS
servers. The RADIUS server should be configured before using this command. This
command fails if the primary and secondary RADIUS servers are not configured.
The following types of management sessions can be configured:
• Telnet
• SSH
• Console
• HTTP
If you are using RADIUS authentication servers, you should only use RADIUS accounting servers for
accounting management sessions. RADIUS authentication servers should be configured before
configuring RADIUS accounting servers for management sessions.
Example
In the following example, management sessions are configured for RADIUS:
configure auth mgmt-access radius primary 192.168.14.12 secondary 192.168.14.55
History
This command was first available in ExtremeWare 7.3.0 and ExtremeWare 7.3e.
858 ExtremeWare 7.7 Command Reference Guide