Rep 56.7.1 Dadf Drive Belt - Xerox WorkCentre 5021 Service Documentation

Figure 2 j0lj45630
Initial Issue
WorkCentre 5021/5019

REP 56.7.1 DADF Drive Belt

Parts List on PL 56.7
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the DADF Front Cover.
2. Remove the DADF Rear Cover.
3. Remove the Document Tray.
4. Remove the Harness Guide and the wire harness.
5. Remove the DADF Feed Motor.
6. Remove the link. (Figure 1)
(1) Remove the link.
7. Remove the gear and bracket. (Figure 2)
(1) Remove the washer (large: thin).
(2) Remove the washer (small: thick).
(3) Remove the gear and bracket.
08/2012
4-75
WARNING
(REP 56.2.1)
(REP 56.2.2)
(REP 56.9.1)
(REP 56.6.1)
(REP 56.6.2)
Figure 1 j0lj45631
Repairs and Adjustments
REP 56.6.2, REP 56.7.1