Introduction - Siemens SIMOCODE pro System Manual

Motor management and control devices

Hide thumbs Also See for SIMOCODE pro:

Table of Contents

Standard functions

Introduction

So-called "Standard functions" in the form of function blocks are also stored

in SIMOCODE pro, and can be used as required. These function blocks may

• Setting values, e.g. the response when external faults occur ("Signaling",

"Warning" or "Tripping").

The following schematic shows the general representation of the function

block of a standard function:

Fig. 10-1: General representation of the function block of a standard function

Extent and application

These function blocks work independently of the selected control function

and can be used as optional supplements. They are ready to be used and

only require activating by connecting the plug(s) of the respective function

Depending on the device series, the system offers several different function

blocks for such standard functions:

Test Position Feedback (TPF)

External Fault

Operational Protection OFF (OPO)

Power Failure Monitoring (UVO)

Emergency Start

Watchdog (PLC/PCS Monitoring)

Table 10-1: Function blocks

) in the form of status information

Standard Function

Function block

Socket 1 - n

Setting value

GWA 4NEB 631 6050-22 DS 03

SIMOCODE pro