11.9
Flashing
Description
If an input signal is pending at its plug, the "Flashing" logic module provides
a signal at its socket, which alternates between binary 0 and 1 with a fixed
frequency of 1 Hz. You can use this to make the LEDs on the operator panel
flash.
The logic module consists of:
• One plug
• One logic component
• One socket.
Overall, three logic modules, "Flashing 1" through to "Flashing 3" are available
for BU1 and BU2.
Schematic
The following schematic shows the "Flashing" logic modules
Input
Input
Fig. 11-16: "Flashing" logic modules
Settings
Flashing 1 to 3 -
Input
Table 11-10: Flashing settings
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
Flashing 1
Output
Flashing 3
Output
Activation by any signal
(any sockets
, e.g. device inputs, status information, status, etc.)
Flashing 2
Input
Description
Logic modules
Output
11-21