Siemens SIMOCODE pro System Manual page 77

Motor management and control devices

Hide thumbs Also See for SIMOCODE pro:

Table of Contents

Calculator 1 (example)

Calculator 2 (example)

Energy consumed (example)

Table 1-10: Read and adapt main display (Cont.)

If measured values are not depicted on the main display for a sustained

period of time, a profile has been selected in the display settings that is no

longer supported, due, for example, to a changed system expansion or

changed hardware configuration. The profile must be reselected.

SIMOCODE pro

GWA 4NEB 631 6050-22 DS 03

Displays the calculated result that the function block Calculator 1

provides, unitless in the range of 0 to 65535.

Enables, for example, the depiction on the switchgear display of a

2-byte value sent directly from the automation system, i.e. the

unitless depiction of all 2-byte values available in SIMOCODE pro.

Displays the calculated result that the function block Calculator 2

provides, unitless in the range of 0 to 65535.

Enables, for example, the depiction on the switchgear display of a

2-byte or 4-byte value sent directly from the automation system, i.e.

the unitless depiction of all 2 or 4-byte values available in

SIMOCODE pro.

Only possible if a current/voltage measuring module is being used

and the OPD is above version *E04*.

System description