Siemens SIMOCODE pro System Manual page 207

Settings
You will find detailed information about the settings in:
Chapter 4.2.2 "General settings and
Circuit breaker
OFF
ON >
FB ON
Non-maintained
command mode
Separate failsafe
function from
control function
Load type
Feedback time
Execution time
Table 4-9: Circuit breaker settings
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
definitions".
OFF control command
(connection with arbitrary socket
usually with "Enabled control command - OFF" socket)
ON control command
(connection with arbitrary socket
usually with "Enabled control command - ON >" socket)
Auxiliary control input "Feedback ON"
(Connection always with socket
switch of the circuit breaker is connected to).
• Deactivated
• Activated
• Deactivated:
Safety-oriented tripping via the DM-F module also affects the
SIMOCODE pro control function, so that additional fault
messages are avoided.
This setting is selected for applications where safety-oriented
tripping directly affects the motor controlled by SIMOCODE pro.
• Activated:
Safety-oriented tripping via the DM-F module does not affect the
SIMOCODE pro control function.
This setting is selected for applications where safety-oriented
tripping does not affect the motor controlled by SIMOCODE pro.
You can choose between:
• Motor
• Resistive load (see Chapter 4.2.2 "General settings and
definitions")
A repeated ON pulse is only output by the QE1 contactor control
once the set feedback time has elapsed. Therefore, the feedback
time should be greater than the motor stop time of the motor drive
of the circuit breaker. Range 0 - 25.5 seconds (0.5 s)
Range 0 - 6553.5 seconds (1.0 s)
Motor control
Description
,
,
, (input), which the auxiliary
4-29