Technical Data Of The Dm-F Profisafe Digital Module - Siemens SIMOCODE pro System Manual

D.5.4

Technical data of the DM-F PROFIsafe digital module

LED display
DM-F PROFIsafe
"READY"
"DEVICE"
"OUT"
"GF"
"1"
"2"
"3"
"4"
"5"
"6"
"7"
"8"
"9"
"10"
DIP switch
SET/RESET button
Inputs (binary)
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
Color Meaning
OFF System interface disconnected/supply voltage too
low/device defective
Green Device is ready for operation/system interface OK
Flashing Device is ready for operation/system interface is
green inactive or faulty
OFF Supply voltage too low
Green Device is ready for operation
Red Device is defective or interrupted
OFF Safety-oriented output inactive
Green Safety-oriented output active
Flashing Feedback circuit not closed when starting condition
green has been fulfilled
OFF No general fault
Red General fault (PROFIsafe inactive, incorrect PROFIsafe
address, wiring fault, device defective)
Yellow PROFIsafe address 1
Yellow PROFIsafe address 2
Yellow PROFIsafe address 4
Yellow PROFIsafe address 8
Yellow PROFIsafe address 16
Yellow PROFIsafe address 32
Yellow PROFIsafe address 64
Yellow PROFIsafe address 128
Yellow PROFIsafe address 256
Yellow PROFIsafe address 512
Setting of the safety functions
Application of parameters set via DIP switch
•
• Resetting of faults (also possible via "TEST/RESET" onbasic unit)
• 3 inputs 24 V DC (83, 85, 89)
• Supply via terminal 84 or external supply
• Common connected, electrically isolated inputs for acquiring process-
signals (e.g., local control station, keyswitch, limit switch, etc.), fre-
elassignable to control functions
Technical data
D-17