Siemens SIMOCODE pro System Manual page 544

Data formats and data records
B.21.10 Pole-changing reversing starter
Bit 0.0
Bit 0.1
Bit 0.2
Bit 0.3
Bit 0.4
Bit 0.5
Bit 0.6
Bit 0.7
Bit 1.0
Bit 1.1
Bit 1.2
Bit 1.3
Bit 1.4
Bit 1.5
Bit 1.6
Bit 1.7
Byte 2/3 *) (analog value)
Bit 0.0
Bit 0.1
Bit 0.2
Bit 0.3
Bit 0.4
Bit 0.5
Bit 0.6
Bit 0.7
Bit 1.0
Bit 1.1
Bit 1.2
Bit 1.3
Bit 1.4
Bit 1.5
Bit 1.6
Bit 1.7
Byte 2/3 (analog value)
Byte 4/5 *) (analog value)
Byte 6/7 *) (analog value)
Byte 8/9 *) (analog value)
Table B-31:
*) for SIMOCODE pro V, basic type 1 only
B-54
Cyclic receive data
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> ON >>
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> OFF
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> ON >
Further function blocks -> Standard functions - Test/Reset -> Test 1 - Input
Further function blocks -> Standard functions -> Emergency start -> Emergency start - Input
Device parameters -> Motor control -> Control stations -> Mode selector S1
Further function blocks -> Standard functions -> Test/Reset -> Reset 1 - Input
Not connected
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> ON <<
Not connected
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> ON <
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Cyclic send data
Status - ON >>
Status - OFF
Status - ON >
Event - Pre-warning overload (I>115 %)
Status - Change-over pause active
Status - Remote mode
Status - General fault
Status - General warning
Status - ON <<
Not connected
Status ON <
Status - Interlocking time active
Not connected
Not connected
Not connected
Not connected
Maximum current I_max
Not connected
Not connected
Not connected
Assignment of cyclic receive/send data, pole-changing reversing starter
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03