Siemens SIMOCODE pro System Manual page 280

Motor management and control devices

Hide thumbs Also See for SIMOCODE pro:

Table of Contents

Application examples

• Controlling the motor contactor in the motor feeder

You can define which relay output is to be used for controlling the main

contactor in the motor feeder.

For this, connect the desired relay output to the respective "QE" contactor

control of the control function.

• Controlling lamps for displaying operating states:

You can define which relay outputs are to be used for controlling the lamps/

LEDs that display the operating states of the motor (Fault, ON, OFF, Fast,

For this, connect the desired relay output to the respective "QL..." lamp

control of the control function.

• Transfer of any other information, status information, warnings, faults, etc. to

the relay outputs.

In many cases, the outputs of the digital module will be connected to the

QE outputs. By referring to

which QE outputs are required for which control functions.

Outputs 1 to 2

Table 6-4: "DM1/DM2 Outputs" settings

Defaults depend on the selected application (template): See

Table 4-21 on page 4-65

Control of the "DM1 Outputs" and "DM2 Outputs" function blocks

with any signal

(any sockets

e.g. device inputs, control bits from PROFIBUS DP , etc.

usually from the QE contactor controls)

you can determine

GWA 4NEB 631 6050-22 DS 03

SIMOCODE pro