Siemens SIMOCODE pro System Manual page 543

B.21.9 Pole changing starter
Bit 0.0
Bit 0.1
Bit 0.2
Bit 0.3
Bit 0.4
Bit 0.5
Bit 0.6
Bit 0.7
Bit 1.0
Bit 1.1
Bit 1.2
Bit 1.3
Bit 1.4
Bit 1.5
Bit 1.6
Bit 1.7
Byte 2/3 *) (analog value)
Bit 0.0
Bit 0.1
Bit 0.2
Bit 0.3
Bit 0.4
Bit 0.5
Bit 0.6
Bit 0.7
Bit 1.0
Bit 1.1
Bit 1.2
Bit 1.3
Bit 1.4
Bit 1.5
Bit 1.6
Bit 1.7
Byte 2/3 (analog value)
Byte 4/5 *) (analog value)
Byte 6/7 *) (analog value)
Byte 8/9 *) (analog value)
Table B-30: Assignment of cyclic receive/send data, pole-changing starter
*) for SIMOCODE pro V, basic type 1 only
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
Cyclic receive data
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> ON >>
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> OFF
Device parameters -> Motor control -> Control stations -> PLC/PCS [DP] -> ON >
Further function blocks -> Standard functions - Test/Reset -> Test 1 - Input
Further function blocks -> Standard functions -> Emergency start -> Emergency start - Input
Device parameters -> Motor control -> Control stations -> Mode selector S1
Further function blocks -> Standard functions -> Test/Reset -> Reset 1 - Input
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Cyclic send data
Status - ON >>
Status - OFF
Status - ON >
Event - Pre-warning overload (I>115 %)
Status - Change-over pause active
Status - Remote mode
Status - General fault
Status - General warning
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Not connected
Maximum current I_max
Not connected
Not connected
Not connected
Data formats and data records
B-53