Siemens SIMOCODE pro System Manual page 471

Event Description
(alphabetical)
Required At least one parameterized
function is not function is not supported by the
supported version of the basic unit.
Stalled The torque switch has activated
positioner before or without the respective
limit switch.
Stalled rotor The maximum motor current has
exceeded the threshold for
stalled rotor protection.
Possible cause: The motor is
blocked.
Start-up The start-up parameter block
parameter block prevents adoption of
active SIMOCODE pro parameters that
can be saved in the DP Master.
The block must be set when:
• SIMOCODE ES
or
• SIMATIC PDM
is used for parameterizing.
The block may not be set if:
• SIMOCODE pro C/V is
integrated in STEP7 via the
SIMOCODE pro object
manager (OM)
or
• SIMOCODE pro C has been
parameterized via GSD.
Notice
The parameter block is not active
in the case of devices that are st
set to the factory settings or
devices that have been reset to
the factory settings!
Status - Cooling The motor feeder has been
down period switched off due to overload.
active
Table 15-1: Alarms, faults and system events (Cont.)
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
Alarms, faults and system events
Troubleshooting Acknowledg
ement/fault
rectification
Activate only the
functions that are
supported by the version
of the basic unit.
For example,
SIMOCODE pro V basic
units with the version
*E01* do not support
voltage measurement,
the temperature module
or the analog module.
• The positioner may be "OPEN/
blocked. CLOSED"
• Acknowledge the fault counter
by releasing with the command.
"OPEN/CLOSED"
counter command.
• Please check the
positioner application
and the limit switches
Please check the Reset
application that is being
driven by the motor.
The motor can only be
switched on again after
the cooling down period
has expired.
Contactor Error
control no.*)
Tripped 12
Tripped 48
15-7