Introduction - Siemens SIMATIC ET 200SP Operating Instructions Manual

Introduction

Purpose of the documentation
These operating instructions supplement the system manual ET 200SP distributed I/O system.
Functions that generally relate to the system are described in this manual.
The information provided in these operating instructions and in the system/function manuals
supports you in commissioning the CPU 1515SP PC2.
Basic knowledge required
The system must be operated and used by qualified staff only.
The following knowledge is required:
• Installation guideline for SIMATIC ET 200SP
• Totally Integrated Automation Portal, in particular:
– Hardware configuration with hardware and network editor
– Communication between CPUs
• PC-based automation with an S7‑1500 Software Controller
• Basic knowledge of fail-safe automation systems
• Basic knowledge of PC technology
• Windows 10 IoT Enterprise operating system (64-bit LTSC 2021)
Conventions
STEP 7: In this documentation, "STEP 7" is used as a synonym for all versions of the
configuration and programming software "STEP 7 (TIA Portal)".
"CPU 1515SP PC2 T" means that the respective section applies only to the "CPU 1515SP PC2 T".
"CPU 1515SP PC2 F" means that the respective section applies only to the "CPU 1515SP PC2 F".
"CPU 1515SP PC2 TF" means that the respective section applies only to the
"CPU 1515SP PC2 TF".
"CPU 1515SP PC2" also includes "CPU 1515SP PC2 F", "CPU 1515SP PC2 T" and
"CPU 1515SP PC2 TF".
Please also observe notes marked as follows:
Note
A note contains important information on the product described in the documentation, on the
handling of the product or on the section of the documentation to which particular attention
should be paid.
CPU 1515SP PC2 (F/T/TF)
Operating Instructions, 03/2023, A5E42603425-AC
1
7