Siemens SIMOCODE pro System Manual page 189

Control function schematic
The following schematic shows the general representation of the control
function ("Protection/Control", "Extended Control" and "Extended Protection"
function blocks):
Plugs of the control commands are usually
connected with the "Enabled control
command" sockets.
Control stations
*) Abbreviations
FB ON
FC
FO
TC
TO
**) See also
protection"
Fig. 4-8: General representation of the control function ("Protection/Control" function block)
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
Control commands
ON <<
ON <<
ON <
ON <
OFF
OFF
ON >
ON >
ON >>
ON >>
Enabled
Control
command
Aux. control inputs *)
FB ON
FC
FO
TC
TO
Feedback ON
Feedback CLOSED
Feedback OPEN
Torque CLOSED
Torque OPEN
Chapter 3 "Motor
Contactor controls
QE1
Protection/Control
QE2
Control function
QE3
(Motor protection **)
QE4
QE5
Settings:
QLE <<
(ON <<)
•Control commands
QLE <
•Auxiliary control inputs
(ON <)
QLA
(OFF)
QLE >
(ON >)
QLE >>
(ON >>)
QLS
(Fault)
Status information,
e.g. PROFIBUS DP
ON <<
ON <
OFF
ON >
ON >>
Motor control
Displays (lamp
control)
Pos. opening
Pos. closing
4-11