Siemens SIMOCODE pro System Manual page 35

Monitoring additional process variables via the analog module
SIMOCODE pro V allows measuring and monitoring of any other process
variables via the analog module.
For example, the fill level can be monitored to protect a pump against dry
operation, or a differential pressure transducer can be used to monitor the
degree of pollution in a filter. If the fill level undershoots a specified level,
the pump can be switched off and, if a specific differential pressure value is
exceeded, the filter is to be cleaned.
SIMOCODE pro V supports two-phase monitoring of the corresponding
process variables for freely-selectable upper and lower limits. The
SIMOCODE pro V response can be freely parameterized and delayed upon
reaching a pre-warning or trip level.
Phase sequence identification
SIMOCODE pro allows the direction of rotation of a motor to be determined
by identification of the phase sequence. If the direction of rotation is wrong,
a signal can be generated or the motor switched off.
See "Menu of the operator panel with display"
the operator panel with
Monitoring any measured values using unrestricted limit monitors
SIMOCODE pro can monitor every measured value in the system for
undershooting or overshooting a set threshold value by means of
unrestricted limit monitors.
See Chapter 11.11 "Limit
1) When using basic unit 2
2) When using basic unit 2 with current/voltage measuring module
3) Additional temperature module required
4) Additional analog module required
5) Additional earth-fault module and summation current transformer required.
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
2)
display".
monitor".
System description
1) 4)
and "Navigating the menu of
1)
1-17