Siemens SIMOCODE pro System Manual page 186

Motor control
Example:
Enabled commands
The following diagram shows an example of enabled commands for the
"Local 2" operating mode, "Dahlander reversing starter" control function:
Fig. 4-7: Example for enabled commands
In the example, the motor can only be switched on and off in the "Local 2"
operating mode via the buttons (local) connected to the inputs of the basic
unit and the digital module.
4-8
Control commands "ON" (ON<<, ON<, ON>, ON>>)"
enabled
Control command "OFF" enabled
To the control function
"Protection/Control"
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03