Using Digi Remote Manager; Using The Local Web Interface - Digi LR54 User Manual

Firmware configuration
Command line.
n
A robust command line allows you to perform all configuration and management tasks from
within a command shell. Both the Remote Manager and the local web interface also have the
option to open a terminal emulator for executing commands on your LR54 device. See
the command line
configure your LR54 device.
In this guide, task topics show how to perform tasks:

Web
Shows how to perform a task by using the local web interface.

Command line
Shows how to perform a task by using the command line interface.

Using Digi Remote Manager

By default, your LR54 device is configured to use Digi Remote Manager as its central management
server. Devices must be registered with Remote Manager, either:
As part of the getting started process. See the
n
If you have not registered your device already, you can add a device to Remote Manager. See
n
Add a device to Digi Remote
For information about configuring central management for your LR54 device, see
management.

Using the local web interface

To connect to the LR54 local Web UI:
1. Use an Ethernet cable to connect the LR54's ETH2 port to a laptop or PC.
2. Open a browser and go to 192.168.2.1.
3. Log into the device using a configured user name and password.
The default user name is admin and the default password is the unique password printed on
the label packaged with your device.
Note If your device was manufactured prior to firmware version 19.11.x, the default user for
logging into the device may be root, rather than admin.
The default user is root:
n
l
l
The default user is admin:
n
l
l
After logging in, the local web admin dashboard is displayed.
LR54 User Guide
for more information about using the command line to manage and
Manager.
If the device is at a firmware level 19.8.x or older.
If the device has been upgraded from 19.8.x or older to 19.11.x or newer.
If the device is at 19.11.x or newer when manufactured.
If the device has been upgraded from 19.8.x or older to 19.11.x or newer and has
been factory reset after the upgrade.
Using Digi Remote Manager
Quick Start Guide for further information.
Using
Central
43