Interfaces
(Optional) Repeat to add additional test targets.
9. Optional active recovery configuration parameters:
LR54 User Guide
(config network interface my_wan ipv4 surelink target 0)> other
value
(config network interface my_wan ipv4 surelink target 0)>
If other is set:
Set the alternate interface to be tested:
o
i. Use the ? to determine available interfaces:
(config network interface my_wan ipv4 surelink target
0)> other_interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan1
/network/interface/lan_hotspot
/network/interface/loopback
/network/interface/wan1
/network/interface/wwan
Current value:
(config network interface my_wan ipv4 surelink target
0)> other_interface
ii. Set the interface. For example:
(config network interface my_wan ipv4 surelink target
0)> other_interface /network/interface/wan1
(config network interface my_wan ipv4 surelink target
0)>
Set the alternate interface's IP version. This allows you to determine the
o
alternate interface's status for a particular IP version.
(config network interface my_wan ipv4 surelink target 0)>
other_ip_version value
(config network interface my_wan ipv4 surelink target 0)>
where value is one of: any, both, ipv4, or ipv6.
o
Set the expected status of the alternate interface:
(config network interface my_wan ipv4 surelink target 0)>
other_status value
(config network interface my_wan ipv4 surelink target 0)>
where value is either up or down. For example, if other_status is set to down,
but the alternate interface is determined to be up, then this test will fail.
Wide Area Networks (WANs)
93