Digi LR54 User Manual page 967

Monitoring
Note If Static transmitter filtering is enabled, to view devices that have been
automatically determined to be stationary and therefore filtered out of output log:
n
n
You can also view devices that have not yet been filtered out but are being considered for
automatic blocklisting:
n
n
11. (Optional) Configure the device to push Wi-Fi scanner results to one or more remote servers:
a. Click to expand Push scanner results.
b. Click Enable.
c. For Interface, select the network interface on the device that will be used to push the Wi-
Fi scanner results.
d. Click to expand Remote Servers.
e. For Add server, click .
f. For Server Address, type the hostname or IPv4 address of the remote server.
g. For Server port, type the port number on the remote server that will be used for the Wi-Fi
scanner results.
h. For Protocol, select the protocol that the device should use to upload the Wi-Fi scanner
results to the remote server.
i. For Compress, select Enable compression to compress the data being sent to the remote
host. The default is Disable compression.
j. Repeat for additional remote hosts.
LR54 User Guide
From the Web UI: Click Status > Wi-Fi scanner. Devices that have been
automatically filtered out of output log are listed under Blocklisted static
transmitters.
From the Admin CLI: Use the command show wifi-scanner blocklist to show
devices that have been automatically filtered out of output log.
From the Web UI: Click Status > Wi-Fi scanner. Devices that have not yet been
filitered out but are being considered are listed under Candidate static
transmitters.
From the Admin CLI: Use the command show wifi-scanner candidates to show
devices that are being considered for automatic blocklist.
Enable the Wi-Fi scanner
967