Configure Device Two (Backup Device) - Digi LR54 User Manual

Hide thumbs Also See for LR54:

Table of Contents

Task 3: Configure the IP address for the VRRP interface, LAN1, on device one

1. Type ... to return to the root of the config prompt:

(config network vrrp VRRP_test )> ...

2. Set the IP address for LAN1:

(config)> network interface lan1 ipv4 address 192.168.3.1/24

Task 4: Configure the DHCP server for LAN1 on device one

1. Set the start and end addresses of the DHCP pool to use to assign DHCP addresses to clients:

a. Set the start address to 100:

(config)> network interface lan1 ipv4 dhcp_server lease_start 100

b. Set the end address to 199:

(config)> network interface lan1 ipv4 dhcp_server lease_end 199

2. Set the DHCP server gateway type to custom:

(config)> network interface lan1 ipv4 dhcp_server advanced gateway custom

3. Set the custom gateway to 192.168.3.3:

(config)> network interface lan1 ipv4 dhcp_server advanced gateway_custom

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure device two (backup device)

LR54 User Guide

Virtual Router Redundancy Protocol (VRRP)