Digi LR54 User Manual page 950

System administration
3. At the config prompt, type:
(config)> network device eth_port value
where:
eth_port is the name of the Ethernet port (for example, eth1)
n
value is one of:
n
l
l
l
The default is auto.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
LR54 User Guide
10—Sets the speed to 10 Mbps.
100—Sets the speed to 100 Mbps.
1000—Sets the speed to 1 Gbps. Available only for devices with Gigabit Ethernet
ports.
auto—Configures the device to automatically determine the best speed for the
Ethernet port.
Configure the speed of your Ethernet ports
950