Digi LR54 User Manual page 942

System administration
c. For Duration window, select the amount of time that the maintenance tasks will
d. For Frequency, select whether the maintenance window will be started every day,
If Check if Python Out-of-Service is set, the maintenance window will only start if the
n
Python Out-of-Service is set. See
information.
Note If your device is managed by a Digi Remote Manager configuration, the configuration
manages:
The device firmware version.
n
The modem firmware version.
n
The device's configuration settings.
n
You should not enable the Device firmware update, Modem firmware update, and
Configuration check options unless you want the device to automatically check and update
firmware and device configuration outside of the control of Remote Manager. If enabled, you
must configure a Time period for maintenance window trigger type and specify a time window
of when you want the automated firmware checks and updates to occur.
1. Click to enable Device firmware update to instruct the system to look for any
updated device firmware during the maintenance window. If updated firmware
is found, it will then be installed.
2. Click to enable Modem firmware update to instruct the system to look for any
updated modem firmware during the maintenance window. If updated firmware
is found, it will then be installed. Modem firmware update looks for updated
firmware both on the local device and over the network, using either a WAN or
cellular connection.
3. Click to enable Configuration check to allow for the configuration to be
updated, including by custom scripts, during the maintenance window.
10. (Optional) Configure automated checking for device firmware updates:
a. Click to expand Firmware update check.
b. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates.
c. Modem firmware update check is enabled by default. This enables to automated
checking for modem firmware updates.
d. For Frequency, select how often automated checking for device and modem firmware
should take place. Allowed values are Daily, Weekly, and Monthly. The default is Daily.
11. Click Apply to save the configuration and apply the change.

Command line
LR54 User Guide
If Duration window is set to one or more hours, the minutes field in Start time
l
is ignored and the duration window will begin at the beginning of the specified
hour.
be run. If Immediately is selected, all scheduled tasks will begin at the exact time
specified in Start time.
or once per week.
Schedule system maintenance tasks
Use Python to set the maintenance window for further
942