Digi LR54 User Manual page 267

Wi-Fi
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set channel for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
----------------------------------------------------------------------
---------
wifi1
wifi2
(config)> network wifi radio
b. Set the band for the appropriate radio:
(config)> network wifi radio wifi1 band value
(config)>
where value is either 2400mhz or 5000mhz.
c. Set the mode for the Wi-Fi radio. For example:
n
n
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
LR54 User Guide
If the Wi-Fi radio has a band of 2400mhz:
(config)> network wifi radio wifi1 2400mhz mode value
(config)>
where value is one of b, bg, bgn, g, gn, or n.
If the Wi-Fi radio has a band of 5000mhz:
(config)> network wifi radio wifi1 5000mhz mode value
(config)>
where value is one of ac, acn, or n.
Configure the Wi-Fi radio's band and protocol
Wi-Fi1 radio
Wi-Fi2 radio
267