Digi LR54 User Manual page 325

Hotspot
3. Click Network > Hotspots > hotspot.
4. Click to expand IPv4.
5. For Address, enter a new IP address and subnet mask.
6. (Optional) Change the default DHCP server configuration.
Note The hotspot DHCP server is automatically enabled and cannot be disabled.
a. Click to expand DHCP server.
b. For Lease time, type the amount of time that a client DHCP lease is valid. The default is 10
minutes.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Lease time to ten minutes, enter 10m or 600s.
c. For Lease range start, type the lowest IP address in the range to assign to hotspot clients.
The value entered here represents the low order byte of the IP address, and is combined
with the subnet of the hotspot's static IP address. The default is 100.
d. For Lease range end, type the highest IP address in the range to assign to hotspot clients.
The value entered here represents the low order byte of the IP address, and when DHCP
addresses are assigned to client, this number is combined with the subnet of the hotspot's
static IP address. The default is 250.
7. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
LR54 User Guide
Hotspot configuration
325