Enable The Wi-Fi Scanner; Required Configuration; Additional Configuration - Digi LR54 User Manual

Monitoring
9. Add collectors:
a. Add a collector:
(config)> add monitoring netflow collector end
(config monitoring netflow collector 0)>
b. Set the IP address of the collector:
(config monitoring netflow collector 0)> address ip_address
(config monitoring netflow collector 0)>
c. (Optional) Set the port used by the collector:
(config monitoring netflow collector 0)> port port
(config monitoring netflow collector 0)>
d. (Optional) Set a label for the collector:
(config monitoring netflow collector 0)> label "This is a collector."
(config monitoring netflow collector 0)>
Repeat to add additional collectors.
10. Save the configuration and apply the change:
(config monitoring netflow collector 0)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable the Wi-Fi scanner

The Wi-Fi scanner allows you to configure your device to detect Wi-Fi-enabled devices that are nearby,
and then opens an SSH port that remote hosts can access to read basic information about those
devices.
For users to view the output of the Wi-Fi scanner, they must be a member of an authentication group
that has Wi-Fi scanner access enabled. See
configuration information.

Required configuration

Enable the Wi-Fi scanner.
n
The wireless radio to use for scanning.
n

Additional configuration

The SSH port used by the Wi-Fi scanner for reporting information to the remote host.
n
The Wi-Fi channels to be scanned.
n
LR54 User Guide
Add an authentication group
Enable the Wi-Fi scanner
for authentication group
963